Kata Kunci
Nickel Slag
Compressive Strength
Normal Concrete.
Abstrak
Indonesia is the largest nickel producer in the world. but from another aspect, the problem of ex-mining pits, combustion ash waste, nickel slag and others are environmental issues in the nickel mining industry (nikel.co.id, 2020). Currently, the Ministry of Industry through the research and development unit is trying to raise the potential of nickel slag or slag so that it can be used as industrial raw material that is in line with environmental management in the context of a sustainable economic program (antaranews.com, 2020). Based of this study was conducted on the use of nickel slag as a substitute for coarse aggregate in concrete. This research is an experimental study with the objectives of analyzing the physical and mechanical characteristics of nickel slag, analyzing the compressive strength of concrete using nickel slag as a substitute for coarse aggregate, and analyzing the optimal percentage of nickel slag used as a substitute for coarse aggregate. The results of this study indicate that the use of nickel slag as a substitute for coarse aggregate for 20 MPa concrete, and unable to achieve the planned average compressive strength of 20 MPa plus a margin of 12 MPa, resulted in a decrease in compressive strength and did not provide quality improvement. concrete. The application of nickel slag as a substitute for coarse aggregate in structural concrete with a design compressive strength ≥ 20 MPa is not recommended.
Referensi
analisis.id. (2020, 5). http://www.analisis.id/proses-pemurnian-pengolahan-nikel-nickel-refinery. Retrieved from www.analisis.id: www.analisis.id/proses-pemurnian-pengolahan-nikel-nickel-refinery
Aprianto, Y., & Triastianti, R. D. (2018). Pemanfaatan Limbah Padat Slag Nikel, Sekam Padi dan Fly Ash Menjadi Paving Block. Jurnal Rekayasa Lingkungan, 1-12.
Aprilia, P., Phengkarsa, F., & Kusuma, B. (2021). Studi Eksperimental Beton Mutu Normal Dengan Agregat Batok Kelapa Dan Terak Nikel. Paulus Civil Engineering Journal (PCEJ), 655-664.
Baharuddin, I. I., Imran, A. M., Maulana, A., & Hamzah, A. (2021). Karakterisasi Fisik dan Kimia Slag Feronikel Kecamatan Pomalaa Sulawesi Tenggara. Jurnal Ilmu Alam dan Lingkungan, 7-16.
Botahala, L., & Pasae, Y. (2020). Kimia Semen; Suatu Kajian Literatur Ilmiah. April: Deepublish.
Ganti, A. (2008). Potensi pemanfaatan low nickel slag dalam beton sebagai pengganti semen dan agregat kasar. Surabaya: Petra Christian University.
Hartono, Y. D., Aswad, N. H., Mursidi, B., & Nurbaity, D. P. (2021). Analisis Pengaruh Suhu Tinggi Terhadap Kuat Tekan Beton Yang Menggunakan Terak Nikel Sebagai Agregat Kasar. Jurnal Radial, 210-220.
Hijriah, H., & Yunianti, N. H. (2021). Pemanfaatan Limbah Iron Slag Sebagai Material Pengganti Sebagian Pasir Pada Produksi Beton. TAPAK; Teknologi Aplikasi Konstruksi, 117-123.
Jalali, A. N., Halim, H. H., & Salim, A. A. (2017). Penggunaan Slag Nikel Dalam Pembuatan Paving Block. Prosiding Seminar Hasil Penelitian (SNP2M) 2017 (pp. 166 - 171). Makassar: E-Journal PNUP.
Kaselle, H., & Allo, R. B. (2021). Pengaruh Penggunaan Slag Nikel Pada Kuat Tekan dan Kuat Lentur Beton Geopolimer. Journal of Applied Civil and Environmental Engineering, 60-73.
Masril. (2020). Perbandingan Kuat Tekan Beton Antara Campuran Aggregat Kasar Batu Pecah Dengan Aggregat Kasar Batu Alam Payakumbuh Untuk Beton Struktur. Ensiklopedia of Journal, 123-129.
Mustika, W. W., Salain, I. A., & Sudarsana, K. I. (2016). Penggunaan Terak Nikel Sebagai Agregat Dalam Campuran Beton. Jurnal Spektran, 36 - 45.
Nikel.co.id. (2020, 12 16). https://nikel.co.id/. Retrieved from nikel.co.id: https://nikel.co.id/bukan-cuma-lubang-tambang-limbah-smelter-juga-masih-bermasalah/
Rahmawati , S., & Suhendro, N. (2017). Pengaruh Ukuran Maksimum Dan Nilai Kekerasan Agregat Kasar Terhadap Kuat Tekan Beton Normal. Surakarta: Universitas Muhammadiyah Surakarta.
Siti Harlina-detikFinance. (2019, 2 25). https://finance.detik.com/industri/. Retrieved from https://finance.detik.com/: https://finance.detik.com/industri/d-4442720/smelter-rp-14-triliun-beroperasi-di-sulawesi-tenggara
Susilowati, D., Saputro, I. N., & Nurhidayati, A. (2013). Pengaruh Penggunaan Terak Sebagai Pengganti Agregat Kasar Terhadap Kuat Lentur Dan Berat Jenis Beton Normal Dengan Metode Mix Design. Pendidikan Teknik Bangunan, 1-7.
Suwindu, K. S., Parung, H., & Sandy, D. (2020). Karakteristik Beton Mutu Tinggi dengan Substitusi Slag Baja dan Slag Nikel Sebagai Agregat Kasar. Paulus Civil Engineering Journal, 8-15.
Taufiq, E. S. (2019). Rancangan Beton Non Pasir Menggunakan Agregat Slag Nikel Fenil Type III. Jurnal Inovasi Sains dan Teknologi (INSTEK), 15-29.
Wijaya, R., & Astutiningsih, S. (2021). Studi Literatur Potensi Pemanfaatan Terak Nikel (Slag Nikel) sebagai Agregat pada Mortar dan Beton. BENTANG; Jurnal Teoritis dan Terapan Bidang Rekayasa Sipil, 93-100.
Zainul, Z., Djamaluddin, D., & Anwar, H. (2018). Analisis Perbandingan Substitusi Slag Pada Semen dan Pasir Pada Campuran Beton Mutu K-225 Pada PT IMIP Kabupaten Morowaliprovinsi Sulawesi Tengah. Jurnal Geomine, 65-70.
Authors who publish in PENA TEKNIK: Jurnal Ilmiah Ilmu-ilmu Teknik agree to the following terms:
- Authors retain copyright and grant the journal right of first publication with the work simultaneously licensed under a Attribution-ShareAlike 4.0 International (CC BY-SA 4.0) License that allows others to share the work with an acknowledgment of the work's authorship and initial publication in this journal.
- Authors are able to enter into separate, additional contractual arrangements for the non-exclusive distribution of the journal's published version of the work (e.g., post it to an institutional repository or publish it in a book), with an acknowledgment of its initial publication in this journal.
- Authors are permitted and encouraged to post their work online (e.g., in institutional repositories or on their website) prior to and during the submission process, as it can lead to productive exchanges, as well as earlier and greater citation of published work.